ZI

Init Zero Enable

ZI

Command Group: Calibration	Access:	Network interfaces:
TAC protected	RW	CANopen	SDO2300sub10
		MODbus	221E,2
ZI - Init Zero Enabled		PROFIbus	read 3,16 write 4,16

Synopsis:
	Command	Response
Get	ZI	Z:<Value>
Set	ZI <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	1
141.184	0	1
141.185	0	1
141.186	0	1
142.181	0	1
142.184	0	1
142.185	0	1
142.186	0	1
143.181	0	1
143.184	0	1
143.185	0	1
72.181	0	1

ZI Initial Zero ON / OFF.

When this is ON the device will perform a Set Zero immediately after power-up if the weight is within 10% (+/-) of CM.
Permitted values are 0 (OFF) or 1 (ON).

Farcory default is 0 (OFF).