TW

Tare Window

TW

Command Group: Checkweigher	Access:	Network interfaces:
	RW	CANopen	SDO2500sub06
		MODbus	240A,2
TW - Set the tare window		PROFIbus	read 38,6 write 38,134

Synopsis:
	Command	Response
Get	TW	W<Value>
Set	TW <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	65535
141.184	0	65535
141.185	0	65535
141.186	0	65535
142.181	0	65535
142.184	0	65535
142.185	0	65535
142.186	0	65535
143.181	0	65535
143.184	0	65535
143.185	0	65535
151.181	0	65535
151.184	0	65535
151.186	0	65535
152.181	0	65535
152.184	0	65535
162.181	0	65535
179.181	0	65535
181.181	0	65535
64.181	0	65535
72.181	0	65535
78.183	0	65535
88.183	0	65535

TW Set the Tare Window in in counts (digits) without decimal point.
Tare window (TW) allows an automatic Tare update.
If TW = 0 this function is not active.
If TW = 100, this means a new tare value will be taken when the net average weight of an empty scale is within 100 counts or division of zero. The new average tare value is calculated over the average tare time defined by TI. If the tare average is outside tare window, the tare will not be updated.
Factory default is 0 (zero).