TR |
Trigger |
TR |
Command Group: Checkweigher | Access: | Network interfaces: | ||
W | CANopen | RPDO2,80 | ||
MODbus | 2062,1,80 | |||
TR - start the measuring cycle in the same way as the hardware trigger input. | PROFIbus | write 24,0 |
|
|
TR Trigger, this command will start the measuring cycle in the same way as the hardware trigger input.
This command is also implemented in the LDM88 Filling firmware (88.184) to start the filling.
For a LDM88 (Check Weigher) operated through an CGM85 the retriggering can also be stopped directly:
CAN: RPDO2,01.