ST |
Set Tare |
ST |
Command Group: Zeroing | Access: | Network interfaces: | ||
W | CANopen | RPDO1,08 | ||
| MODbus | 2061,1,08 | |||
ST - Set the tare point | PROFIbus | write 30,0 | ||
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ST This command will activate the net weighing function by storing the current weight value as a tare.
The weight signal must be “stable” within the limits set by NR (No Motion Range) and NT (NoMotion Time) commands for the “signal stable” bit to be active and set tare command to be accepted.
Note: The LDM88 (all versions) supports writing the Tare value thru:
| CANopen: | SDO2100sub0D |
| MODbus: | 2118,2 |
| PROFIbus: | read 18,13 write 31,13 |