S2

Setpoint 2

S2

Command Group: Setpoints	Access:	Network interfaces:
	RW	CANopen	SDO2600sub03
		MODbus	206C,2 select 2067,1,2
S2 - Set the setpoint 2 value		PROFIbus	read 29,$32 write 29,$62

Synopsis:
	Command	Response
Get	S2	S2:<Value>
Set	S2 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	-999999	999999
141.184	-999999	999999
141.185	-999999	999999
141.186	-999999	999999
142.181	-999999	999999
142.184	-999999	999999
142.185	-999999	999999
142.186	-999999	999999
143.181	-999999	999999
143.184	-999999	999999
143.185	-999999	999999
151.181	-999999	999999
151.184	-999999	999999
151.186	-999999	999999
152.181	-999999	999999
152.184	-999999	999999
64.181	-999999	999999
72.181	-99999	99999
88.183	-262143	262143

S2 Set the setpoint for channel 2. This is the trigger level that causes action of the output channel relay, according to the settings of the controls A2, H2 and P2.
Issuing the S2 command without any parameters returns the current value in the form S2:+00001.

See also A0, A1, A2, A3, S0, S1, S3, H0, H1, H2, H3, P1, P2, P3.