RS

Read Serial

RS

Command Group: Standard

Access:

Network interfaces:

R

CANopen

SDO2900sub0C

MODbus

2034,2

RS - Read device serial number.

PROFIbus

read 46,0

Synopsis:
CommandResponse
GetRSS<Value>
Valid forMin. valueMax. value
141.181 0 99999999
141.184 0 99999999
141.185 0 99999999
141.186 0 99999999
142.181 0 99999999
142.184 0 99999999
142.185 0 99999999
142.186 0 99999999
143.181 0 99999999
143.184 0 99999999
143.185 0 99999999
151.181 0 99999999
151.184 0 99999999
151.186 0 99999999
152.181 0 99999999
152.184 0 99999999
162.181 0 99999999
179.181 0 99999999
181.181 0 99999999
64.181 0 99999999
64.184 0 99999999
68.181 0 99999999
68.183 0 99999999
69.181 0 99999999
78.183 0 99999999
88.183 0 99999999
88.184 0 99999999
88.185 0 99999999


RS Read device serial number.
This command is currently being implemented in the H&B prouct range.
For the LDM88 RS is implemented from Firmware LDM88.18x.v.2.23.

Units which have not been programmed with serial number will show serial number 0 (Zero) or -1 (minus one) when using new Firmware.

Note: The CanOpen CiA DS301 says that the serial number should be available at index 1018h, subindex 04h as part of the idendity object.
Reading 1018sub04 on a MCS-64/System80 returns the serial number of the Gateway for CGM85 units shipped from H&B after May 2010.