OM

IO mask

OM

Command Group: DigitalIO	Access:	Network interfaces:
	RW	CANopen	SDO2100sub0C
		MODbus	2116,2
OM - Set the IO mask.		PROFIbus	read 18,12 write 31,12

Synopsis:
	Command	Response
Get	OM	OM:<Value>
Set	OM <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	111
141.184	0	111
141.185	0	111
143.181	0	111
143.184	0	111
143.185	0	111
151.181	0	111
152.181	0	111
179.181	0	11
64.181	0	1111
64.184	0	1111
72.181	0	111
72.184	0	111

OM In order to control the outputs from the host application the outputs must be configured using the OM command. A “1” bit in the mask will open the corresponding output channel for outputs from the IO command and a “0” bit will leave the channel controlled by the setpoint. Issuing the OM command without any parameters returns the current mask in the form OM:0011. Change the mask by issuing the IM command with the appropriate four-digit value in the form OM 0001.
NOTE: This command is called IM on other H&B devices.