MR

Multi range

MR

Command Group: Calibration	Access:	Network interfaces:
TAC protected	RW	CANopen	SDO2300sub0D
		MODbus	2218,2
MR - Select multi range.		PROFIbus	read 3,13 write 4,13

Synopsis:
	Command	Response
Get	MR	M<Value>
Set	MR <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	0	1
141.184	0	1
141.185	0	1
141.186	0	1
142.181	0	1
142.184	0	1
142.185	0	1
142.186	0	1
143.181	0	1
143.184	0	1
143.185	0	1
151.181	0	1
151.184	0	1
151.186	0	1
152.181	0	1
152.184	0	1
162.181	0	1
179.181	0	1
181.181	0	1
64.181	0	1
64.184	0	1
69.181	0	1
78.183	0	1

MR Select multi range / multi interval.

0 = Multi interval, where the interval properties changes as the CM(n) limits are crossed.
1 = Multi range, where the highest entered range is kept until the weight reaches zero again.

Issuing the command without any parameters returns the current MR value.
To set a new value for MR, the command must be preceded by the CE XXXXX command, where XXXXX is the current TAC. The new MR value required is then input as a parameter of MR, in the format MR 1. For further information, please see Calibration Procedure.
Factory default setting: 0.

MR is implemented in LDU78 from Firmware 78.183.v.2.47
The actual range can be shown using GG, GN, GL or GW. See OF.

See also CE, CM1, CM2, CM3, OF, GG, GN, GL, GW.