CI |
Set Minimum |
CI |
Command Group: Calibration | Access: | Network interfaces: | ||
TAC protected | RW | CANopen | SDO2300sub08 | |
MODbus | 220E,2 | |||
CI - Set the minimum allowable output value | PROFIbus | read 3,8 write 4,8 |
|
|
CI Set the minimum allowable output value. Issuing the command without any parameters returns the current CI value. This value will determine the point at which the output will change to uuuuuu, signifying under-range. To set a new value for CI, the command must be preceded by the CE XXXXX command, where XXXXX is the current TAC. The new CI value required is then input as a parameter of CI, in the format CI 4010. Factory default setting is the minimum value as indicated above. see Calibration Procedure