AG |
Absolute Gain |
AG |
Command Group: Calibration | Access: | Network interfaces: | ||
| TAC protected | RW | CANopen | SDO2300sub01 | |
| MODbus | 2200,2 | |||
AG - Set the absolute gain point | PROFIbus | read 3,1 write 4,1 | ||
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
AG The command AG is used as absolute gain (or measuring range) for all weight
calculations and will setup in mV/V.
Permitted values are ± 22000 (= ± 2.2000 mV/V) for LDU68, LDU78 and LDM88.
Permitted values are ± 33000 (= ± 3.3000 mV/V) for all others.
Factory default: 20000 @ 2.0000 mV/V input signal.
The serial interface offers two parameters: “mV/V” and “value”.
When calibration is done over the network the second value is taken from the CV register,
except System80/MCS-64 Gateways (for LDM88) that takes the second parameter from the CG value (normally 20000).