DS

Display Step

DS

Command Group: Calibration	Access:	Network interfaces:
TAC protected	RW	CANopen	SDO2300sub0C
		MODbus	2216,2
DS - Set the display step size		PROFIbus	read 3,12 write 4,12

Synopsis:
	Command	Response
Get	DS	S<Value>
Set	DS <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.181	1	500
141.184	1	500
141.185	1	500
141.186	1	500
142.181	1	500
142.184	1	500
142.185	1	500
142.186	1	500
143.181	1	500
143.184	1	500
143.185	1	500
151.181	1	500
151.184	1	500
151.186	1	500
152.181	1	500
152.184	1	500
162.181	1	500
179.181	1	500
181.181	1	500
64.181	1	500
64.184	1	500
68.181	1	200
68.183	1	200
69.181	1	200
72.181	1	200
72.184	1	200
78.183	1	200
78.184	1	200
88.183	1	200
88.184	1	200
88.185	1	200

DS Set the display step size - this allows the output to step up or down by a unit other than 1. Permitted values are 1, 2, 5, 10, 20, 50, 100 and 200. To set a new value for DS, the command must be preceded by the CE XXXXX command, where XXXXX is the current TAC. The new DS value required is then input as a parameter of DS, in the format DS 100. For further information, see Calibration Procedure. Factory default setting: 1